Sears® 625.343920 2-Stage Undercounter Drinking Water System Sears® 625.343921 2-Stage Undercounter Drinking Water System
	Sears® 625.345500 Countertop 1-Stage System. Sears® 625.345510 Countertop 1-Stage System.
	Sears® 625.347001 Reverse Osmosis System Sears® 625.384700 UltraFilter 100 Reverse Osmosis System Use These Manuals For: EcoWater ERO200    EcoWater ERO 300 Northstar NSRO2SF       Northstar NSRO Northstar NSROWF
	Sears® 625.347030 Reverse Osmosis System Sears® 625.347031 Reverse Osmosis System Sears® 625.347050 Reverse Osmosis System Sears® 625.347051 Reverse Osmosis System Use These Manuals For: GE® PN RV18ZBB01, GE® RV18ZBL01,  GE® RV18ZWW01, GE® RV18ZWH01 EcoWater® EcoElite, EcoWater® ERO 292,  EcoWater® ERO 392, EcoWater® ERO 494
	Sears® 625.75639 Countertop 1-Stage System.
EcoWater ERO B524	Installation & Service Manual (Zip File)

CAUTION: BEFORE WORKING ON THE SYSTEM, DO THE FOLLOWING TO RELIEVE WATER PRESSURE IN THE RO TANK.

1a. Turn off the water supply to the RO. b. Close the tank shutoff valve. c. Open the product water faucet and keep it open. d. Disconnect the postfilter. e. Using a 2 gallon container to catch the water, open the tank shutoff valve to empty the storage bladder. 2. Looking at FIG 1, remove the protective cap and depress the relief valve stem, allowing air to ENTER the tank (do not block valve passage). Release the valve stem AFTER flow from the shutoff valve slows to a slight drip. Replace the protective cap. CAUTION: This valve is for vacuum relief only. DO NOT attempt to pressurize the tank with air. 3. Reconnect the postfilter.   To Replace The Postfilter CAUTION: BE SURE TO RELIEVE THE PRESSURE, STEPS 1, 2, AND 3 ABOVE! 1. Disconnect the tubing at both ends (FIG 1). 2. Pull the filter from the holder and remove the fittings from both ends. 3. Observing the FLOW ARROW on the new filter, install the fittings (using teflon tape) into the ends of the new filter. 4. Replace the filter into the holder and reconnect the tubing at both ends.

CAUTION: BE SURE TO RELIEVE THE PRESSURE, STEPS 1, 2, AND 3 ABOVE!

IMPORTANT: Be sure your hands are clean before working on RO system internal parts!

1. Remove the clamp retainers and clamp sections (FIG 1).

2. Separate the cap from the RO housing (you do not have to disconnect the tubing) and set aside.

NOTE: If the cap o-ring seal remained in the RO housing, replace it on the cap.

3. Lift the RO cartridge and prefilter cartridge from the housing, then separate and dispose of the prefilter cartridge.

4. Dump out the remaining water in the RO housing.

5. Slide the RO cartridge INTO THE TOP END of the new prefilter cartridge and then place into the RO housing.

NOTE: BE SURE THE BOTTOM END OF THE PREFILTER IS AT THE BOTTOM, AND THE O-RINGS OF THE RO MEMBRANE ARE AT THE BOTTOM.

6. Be sure the cap o-ring has lubrication. Then push into position and install clamp sections and retainers.

7. If you have the Electronic Monitor, replace the batteries.

8. Turn on the water supply and if you have replaced the RO Membrane, you need to PURGE THE RO MEMBRANE.

Returning System To Service, Purging Instructions

1. Open the water supply valve to the system. Be sure the tank shutoff valve is open.

2. In about 4 hours, pressure will start to build in the RO System. At that time, check your work to be sure there are no water leaks.

3. If the RO membrane was replaced, do the following purging instructions:

NOTE: DO NOT drink the water until after the system has been purged.

After the storage tank has filled (usually about 8 hours), open the drinking water faucet until the system is empty. Allow to fill again and drain system once more. Allow the system to fill and you are ready to use the water.

International Ordering Information RETURN POLICY TDS Meter Instructions Service Manuals & Downloads Testimonials Company Info Sales Info Contact Us Links *The replacement filters and membranes advertised on this site are not manufactured by the companies that manufacture the underlying water treatment equipment unless so noted.  Our use of registered trademarks, such as Culligan®, Kiss®, Premier Manufactured Systems® and others, is only for purposes of identifying compatible replacement filters and membranes, and does not suggest any association, sponsorship or endorsement of our our products by the manufacturers of the underlying equipment. "COMPATIBLE" Legal Disclaimer COPYRIGHT Purewater4u.com is a trademark of Purewater 4U of Las Vegas, Inc. All other products mentioned are registered trademarks or trademarks of their respective companies. Proprietary contents contained herein are the sole property of Purewater4u.com and Purewater 4U of Las Vegas, Inc. and may not be reprinted, reproduced or transmitted in any form without written permission. Purewater 4U of Las Vegas, Inc., grants permission to electronically copy and to print hard copy portions of this site for the sole purpose of placing an order with or through Purewater4u.com, or using this site as a shopping resource. Any other use of materials on this site, including reproduction for purposes other than those noted above, modification, distribution, or republication, without prior written permission from Purewater 4U of Las Vegas, Inc. is strictly prohibited. Copyright © 1998 - 2007 Purewater 4U of Las Vegas, Inc. Las Vegas, NV, USA. All rights reserved.